GRN MNSTR Antik AR1 2015 Hurricane Skates red

$1,299.00

The AR1 boot features high cut, full-grain leather uppers for added ankle support and secure fit, Redesigned fully enclosed, contoured padded suede tongue, All new ‘Ergo-Form’ last for a more anatomical fit, and to reduce toe pinch, All new open toe design for better fit and comfort, Italian made ‘Harmony’ microfibre liner for more comfort and breathability, Heat moldable counters on both sides of the boot, Lace loops at the back of heel for added fit and security, Redesigned achilles area, Integrated shock absorbing foam heel, Contoured heel cup for secure fit and reduced lift, Full-grain leather outsole, stitched for durability, Redesigned Antik ‘A’ panels, Molded, padded heel insoles for maximum cushioning and it's 15% lighter than the AR1 predecessor.

Also included in the package are:
Plate: Powerdyne Arius Aluminium
Wheels: GRN MNSTR Morph wheels
Bearings: GRN MNSTR Moto deluxe
Toe stops: GRN MNSTR Gumball toe stops

Antik boots are made on a D/B last which means there is a B width (narrower) in the heel and a D width (wider) in the toe box. They are also made with a higher toe box giving it a wider feel.

The AR1 hurricane's come with Morph wheels as standard. Please make a note in the comments section as to what colour Morph wheels you would prefer. Magenta/orange is 84A/88A, Orange/lime is 88A/91A, Orange/blue is 88A/93A, Lime/yellow is 91A/95A and Blue/green is 93A/97A.

Antik boots are designed to give the skater extra support particularly when moving laterally.

Click the "size charts" link for help with skate sizes.

Please don't assume that if you wear a size in one brand that the sizing will be the same in another brand as they do differ. In fact, sizing differs between brands with different skates. Please check the size charts.

Heat molding instructions:
Depending on how you want your boots to fit, there are a few options for heat molding the counters and toe area.
Option 1: hair dryer or heat gun
This option is for the individual problem areas (toes, arch, outer foot), and lets you mold one section at a time. Keep the gun/dryer at approx 6-8 inches away from boot, moving in a circular pattern. This should take about 3 min with the heat gun (6 to 7 min with hairdryer). Once the material is pliable, use your hands to push out the problem spot, and hold until cool. This process can be repeated as many times as needed. Note:Hairdryer will take more time to heat molding material.
Option 2: Oven
This option allows you to mold all three spots at once. Mold one boot at a time. Pre-heat oven to lowest setting (79-93 degrees depending on type of oven, DO NOT EXCEED 93 DEGREES OR TIME IN OVEN). Remove sock liner/foot bed, laces, toe stops, wheels and bearings (cushions can be left on). Place boot/skate in oven, on rack or cookie sheet for 3 minutes. Remove boot (Careful, boot will be HOT). Insert sock liner/foot bed, place foot in boot and lace up (be sure to wear the socks you tend to skate in the most). Stand up in boots and wait until cool. If you have a specific hot spot, use your hands to push the spot out or in for the desired fit. This process can be repeated as many times as needed.

Sold Out
  • Shipping Weight: 4kg
  • Manufactured by: Grn Mnstr Rollersports

Please Choose:
Skate Size:
 


This product was added to our catalog on Thursday 26 March, 2015.

Copyright © 2017 Sydney Derby Skates.