Qube Bearing Press/Puller

$129.00

This Suregrip Qube bearing puller/press can be used to quickly press bearings into wheels and to pull them out of the wheels.

To use the puller, start with the handle up and the long pin down (sideways). Then put the wheel on the outside, push the handle down and it pulls the bearing out. Repeat to pull out the other bearing.

To use the press, stand the pin up and put a bearing down on the pin. Next put the wheel with the outside of the wheel (usually the printed side) facing up and put another bearing on the pin. Tip the pin down (sideways) and carefully pull the handle down. You may have to guide the bearings a bit to get started. The aluminum hub wheels may be a bit trickier than the nylon hub or no hub wheels. Do not use excessive force. A very small amount of silicone oil around the outside of the bearing usually helps ease them into the aluminium hub wheels.
Ideally you would mount this bearing puller/press to a table top.

This bearing press works with both 7mm and 8mm bearings.

Add to Cart:

  • Shipping Weight: 0.92kg
  • Manufactured by: Qube Bearings


This product was added to our catalog on Monday 13 January, 2014.

Copyright © 2018 Sydney Derby Skates.